南京冬季市区和郊区气溶胶中PAHs浓度的昼夜特征及粒径分布

为了研究南京市区与郊区气溶胶中多环芳烃(PAHs)污染状况和分布特征,利用气-质联用仪(GC-MS)分析了2010年1月1～10日日间和夜间分别在南京大学和南京信息工程大学采集的气溶胶样品,得到南京市区与郊区17种PAHs浓度,总浓度分别为41.36～220.35 ng.m-3和45.10～200.86 ng.m-3,其中约66%～67%分布于细粒子(Dp≤2.1μm)中.研究发现,南京市区和郊区气溶胶中PAH总浓度均处于较高的水平;但两者昼夜变化趋势不同,即市区PAH总浓度日间高于夜间,郊区PAH总浓度日间低于夜间.主导风向的改变和高压天气系统对PAH浓度变化影响较大;在市区其影响主要表现在细粒子部分,而郊区主要表现在粗粒子部分.市区和郊区不同环数的PAHs粒径分布不同;2～3环PAHs,郊区含量高于市区;而4～6环PAHs,市区含量高于郊区.高环数(4～6环)PAHs在粗模态出现较大浓度峰可能是由于南京地区粗模态气溶胶中碳含量较高.市区和郊区相似的特征比值说明两者的PAHs具有相同污染来源,主要为生物质及煤的燃烧和汽车尾气,表明南京市区PAHs受到郊区工业源排放影响较大.     

2014年北京市城区臭氧超标日浓度特征及与气象条件的关系

根据2014年1~12月北京市环境保护监测中心监测的O₃浓度数据,综合探讨了北京市O₃的时空分布及与其气象条件的关系.结果表明:2014年北京市全年O₃小时平均浓度约为56.18 μg·m^-3,O₃超标日小时平均浓度约为148.05 μg·m^-3且超标日主要集中在5~9月;超标日O₃日变化呈现单峰型分布,06:00或07:00为低谷,15:00、16:00左右达到峰值;超标日O₃浓度在09:00~23:00明显高于夏季同时间段浓度平均;空间分布上中心城区站点O₃浓度相对较低,而城区西部植物园站点浓度最高;统计的2014年北京市O₃超标日地面形势场3种类型高压类、低压类、均压类各占16%、36%、48%;超标日O₃浓度与气压、湿度、能见度呈负相关关系,与风速、温度呈正相关关系; 2014年5月29日~6月1日北京市发生的一次O₃重污染过程是由本地光化学污染及区域输送造成的,区域输送对北京市O₃浓度有着十分重要的影响.     

土壤呼吸与土壤有机碳对不同秸秆还田的响应及其机制

以黄豆、玉米、水稻这3种农业秸秆为原料,崇明东滩围垦土地为试验样区,以景观植物地肤草为目标植物,研究土壤呼吸和土壤有机碳对不同秸秆还田的响应及其可能的机制.结果表明,不同秸秆直接还田的土壤呼吸和地上植物量均高于对照组;黄豆秸秆还田后土壤呼吸相对最低,土壤有机碳最高,因此黄豆秸秆还田的土壤碳封存能力高于玉米和水稻秸秆.秸秆还田显著促进土壤微生物活性,增加了土壤微生物量以及β-糖苷酶、脱氢酶活性,脱氢酶活性与土壤呼吸相关性最显著.黄豆秸秆还田脱氢酶活性最低,相应的土壤呼吸也最低.黄豆秸秆纤维素、木质素和C/N含量最高,可降解性最低,表明黄豆秸秆难以被微生物降解利用,因而还田后其土壤微生物活性最低,最终导致最低的土壤呼吸和较高的土壤有机碳.     

Beyond hypoxia：Occurrence and characteristics of black blooms due to the decomposition of the submerged plant Potamogeton crispus in a shallow lake

Organic matter-induced black blooms(hypoxia and an offensive odor) are a serious ecosystem disasters that have occurred in some large eutrophic shallow lakes in China. In this study, we investigated two separate black blooms that were induced by Potamogeton crispus in Lake Taihu, China. The main physical and chemical characteristics, including color- and odor-related substances, of the black blooms were analyzed. The black blooms were characterized by low dissolved oxygen concentration(close to 0 mg/L), low oxidation-reduction potential, and relatively low pH of overlying water. Notably higher Fe2+and∑S2-were found in the black-bloom waters than in waters not affected by black blooms. The black color of the water may be attributable to the high concentration of these elements, as black FeS was considered to be the main substance causing the black color of blooms in freshwater lakes. Volatile organic sulfur compounds, including dimethyl sulfide, dimethyl disulfide, and dimethyl trisulfide, were very abundant in the black-bloom waters. The massive anoxic degradation of dead Potamogeton crispus plants released dimethyl sulfide, dimethyl disulfide, and dimethyl trisulfide, which were the main odor-causing compounds in the black blooms. The black blooms also induced an increase in ammonium nitrogen and soluble reactive phosphorus levels in the overlying waters. This extreme phenomenon not only heavily influenced the original lake ecosystem but also greatly changed the cycling of Fe, S, and nutrients in the water column.     

Ionic composition of submicron particles (PM1.0) during the long-lasting haze period in January 2013 in Wuhan, central China

In January 2013, a long-lasting severe haze episode occurred in Northern and Central China; at its maximum, it covered a land area of approximately 1.4 million km². In Wuhan, the largest city in Central China, this event was the most severe haze episode in the 21st century. Aerosol samples of submicron particles (PM_1.0) were collected during the long-lasting haze episode at an urban site and a suburban site in Wuhan to investigate the ion characteristics of PM_1.0 in this area. The mass concentrations of PM_1.0 and its water-soluble inorganic ions (WSIIs) were almost at the same levels at two sites, which indicates that PM_1.0 pollution occurs on a regional scale in Wuhan. WSIIs (Na⁺, NH₄⁺, K⁺, Mg²⁺, Ca²⁺, Cl^-, NO₃^- and SO₄^2-) were the dominant chemical species and constituted up to 48.4% and 47.4% of PM_1.0 at WD and TH, respectively. The concentrations of PM_1.0 and WSIIs on haze days were approximately two times higher than on normal days. The ion balance calculations indicate that the particles were more acidic on haze days than on normal days. The results of the back trajectory analysis imply that the high concentrations of PM_1.0 and its water-soluble inorganic ions may be caused by stagnant weather conditions in Wuhan.     

Mo-modified Pd/Al2O3 catalysts for benzene catalytic combustion

Mo-modified Pd/Al2O3catalysts were prepared by an impregnation method and tested for the catalytic combustion of benzene. The catalysts were characterized by N2 isothermal adsorption, X-ray diffraction（XRD）, X-ray photoelectron spectroscopy（XPS）, temperatureprogrammed desorption of NH3（NH3-TPD）, H2temperature-programmed reduction（H2-TPR）, and high-angle annular dark-field scanning transmission electron microscopy（HAADF-STEM）. The results showed that the addition of Mo effectively improved the activity and stability of the Pd/Al2O3catalyst by increasing the dispersion of Pd active components, changing the partial oxidation state of palladium and increasing the oxygen species concentration on the surface of catalyst. In the case of the Pd-Mo/Al2O3catalyst,benzene conversion of 90% was obtained at temperatures as low as 190°C, which was 45°C lower than that for similar performance with the Pd/Al2O3catalyst. Moreover, the 1.0% Pd-5% Mo/Al2O3catalyst was more active than the 2.0% Pd/Al2O3catalyst. It was concluded that Pd and Mo have a synergistic effect in benzene catalytic combustion.     

Review of the progress in preparing nano Ti02： An important environmental engineering material

TiO2 nanomaterial is promising with its high potential and outstanding performance in photocatalytic environmental applications, such as CO2 conversion, water treatment, and air quality control. For many of these applications, the particle size, crystal structure and phase, porosity, and surface area influence the activity of TiO2 dramatically. TiO2 nanomaterials with special structures and morphologies, such as nanospheres, nanowires, nanotubes, nanorods, and nanoflowers are thus synthesized due to their desired characteristics. With an emphasis on the different morphologies of TiO2 and the influence factors in the synthesis, this review summarizes fourteen TiO2 preparation methods, such as the sol-gel method, solvothermal method, and reverse micelle method. The TiO2 formation mechanisms, the advantages and disadvantages of the preparation methods, and the photocatalytic environmental application examples are proposed as well.     

焦化行业苯并芘排放量与厂界达标预测分析

论文以某100万吨/年焦化项目为例,分析其在不同地形和风速参数条件下苯并芘排放量,预测不同条件下距离焦炉炉体中心-1000～1000米范围内各网格点的苯并芘超标概率,最终得出风速、地形参数对苯并芘浓度超标概率的影响.     

建设项目环境保护初探

本文分析了项目建设中存在的问题,包括：环境影响评价、项目建设中的监管以及项目验收监测q-的规范性等问题,并着重从如何保证环境影响评价的质量,项目建设中的监管以及项目验收中的监测规范性等方面提出了对策与建议。     

水库水氯化消毒副产物毒性研究

为了证实水库出水的氯化消毒副产物CHClBr2和CHBr3具有一定的遗传毒性,将水库出水进行浓缩富集研究其对小鼠脾脏淋巴细胞DNA的影响。同时分别与水库枯水期和丰水期出水的小鼠彗星实验结果进行了对比,发现氯化消毒副产物CHClBr2和CHBr3的DNA损伤效应同时高于两个水期的出厂水。